The filter parameters are fully interpolated, so you can modify them without causing any glitches in the audio being processed. In addition, the SVF Control provides a Glide control parameter that allows you to control the interpolation rate. This allows you to configure the filter so that it reacts instantly to parameter changes, or has a slower gliding behavior.

The F parameter allows you to set the center/cutoff frequency of the various filters. The Q parameter allows you to control the resonance at the cutoff frequency. Larger Q's will increase the peaking at the cutoff frequency.

F [0, 5.5k] Hz

Sets the center frequency/corner frequency of the filter.

Q [0.5, 1k]

Sets the quality factor of the filter, and controls the resonance at the cutoff frequency.

Glide [1m, 1]

Sets the glide rate of changes to the other parameters. When the Glide is set to 0, the filter will not change in response to parameter changes. When the glide is set to 1, the filter will change instantaneously. In between values cause the filter to interpolate changes in the parameters at a faster or slower rate.

Gain [-100, 27] dB

Sets the output gain of the filter.